I heard back From Harbor Castings and it will be about a 2-3 week turnaround for my parts. In the meantime the machining fixtures need to be made. Part of the design process is having a decent understanding of how any given part will be made.
In the case of the two swingarm pivot members I knew that the part was a casting and would require a decently complex fixture to hold properly. I knew from experience that the trunnion and baseplate technique works extremely well so would use that as a basis. Knowing what surfaces need to be machined led to a part orientation like this:
The next step is to put a big block of material around the part:
Then add in some fixture points and clamping screws and voila, a useable fixture:
The purple part is an alignment pin, the small red screws are clamping pins that hold the part, and the big red screws are structural members that close the open end of the 'U' shaped fixture. These 2 screws add a lot of stiffness to the overall structure and the complete assembly should allow accurate one-setup machining.
I went through the same process for the chain side part and ended up with the following arrangement:
I am pretty busy with work these days but hope to get to these before the castings get back to me. For the ADV members in our viewing audience that work I need to get done is 2WD stuff!